Displaying A Single Source; Connector Settings - Barco F80 Series User Manual

GUI – Source

6.1 Displaying a single source

About selecting a source
Before a source can be projected, the source signal must be connected to the source input(s) of the device
and a valid synchronization signal must be available along with the source signal on at least one of the input
connectors.
How to select?
1. Press Menu to activate the menus and select Source.
Image 6-1: Select Source
2. Press OK.
The Select Source menu is displayed with the actual available sources filled out.
Image 6-2: Input selection
3. Select the desired input.

6.2 Connector Settings

About Connector Settings
The Connector Settings menu allows you to change settings for each input connector of the projector.
By default all options for every connector are set to automatic, together with the native Extended Display
Identification Data (EDID).
When entering the menu for each input connector, you can change the following:
•
Color Space
•
Signal Range
•
EDID
How to configure a connector
1. Press Menu to activate the menus and select Source.
50 R5906852-01 F80 series