Table of Contents
Advertisement
FatTwin F618R3-FT USER'S MANUAL
6-13 Replacing the Power Supplies
The F418IL chassis includes 1620 Watt power supplies. These power supplies are
auto-switching capable. This enables the power supplies to automatically sense
and operate at a 100v to 240v input voltage. An amber light will be illuminated on
the power supply when the power is off. An illuminated green light indicates that
the power supply is operating.
Power Supply Replacement
The F418IL chassis utilizes redundant, hot-plug power supplies. In the unlikely
event that the power supply unit needs to be replaced, one power supply can be
removed, without powering down the system. Replacement units can be ordered
directly from Supermicro (See the contact information in Chapter 1 of this manual).
Changing the Power Supply
1. Disconnect the AC power cord on the back of the failed power supply.
2. Press the release tab on the back of the power supply and pull the power
supply out using the handle provided.
3. Push the replacement power supply module into the power bay until it clicks
into the locked position.
4. Plug the AC power cord back into the module and power up the node.
Figure 6-16: Changing the F418IL Chassis Power Supplies
6-16
Release Tab
Advertisement
Table of Contents
