Table of Contents
Advertisement
Ti interface drawing
Dimensions and tolerances in mm
16
8
40
4-40 UNC × 2
CAL button operation
Function
Calibration (CAL) routine enable /disable
Automatic Gain Control (AGC) enable/ disable
Restore factory defaults
The dynamic bend radius is not applicable for UHV cables. UHV cables are for static use only.
1
67
62
33.3
Operation
Push and release (< 3 seconds)
Push and release (> 3 seconds)
Push and hold during power 'Off/On' cycle
6 minimum
R > 20 Dynamic bend radius
1
R > 10 Static bend radius
Cover plate
NOTES:
•
For full readhead and interface LED diagnostics, see
•
Only the readhead is UHV compatible. The Ti interface must be kept outside of the
vacuum chamber.
CAL/AGC push button switch
access hole Ø2.4
Diagnostic LED
'System LEDs'
on page 34.
www.renishaw.com
11
Advertisement
Table of Contents
