Table of Contents
Advertisement
3. Refit the cover plate ensuring the cable ferrule is located in the recess on the inside and no wires are trapped under the cover plate.
NOTE: The tightening torque should be between 0.25 Nm and 0.4 Nm.
Disconnecting the readhead
1. Remove the cover plate on the interface (2 × M2.5 hex head screws).
2. Gently lever the connector PCB (on the end of the cable) out of the socket. Do not pull the cable to remove the connector.
3. Place the connector in an anti-static bag.
4. Refit the cover plate.
www.renishaw.com
25
Advertisement
Table of Contents
