Ti Interface Drawing - Renishaw TONiC FS T3 3 Series Functional Safety Installation Manual And Safety Manual

Ti interface drawing

Dimensions and tolerances in mm
16
8
40
4- 40 UNC × 2
CAL button operation
Function
Calibration (CAL) routine enable /disable
Automatic Gain Control (AGC) enable/ disable
Restore factory defaults
1
The dynamic bend radius is not applicable for UHV cables. UHV cables are for static use only.
24 TONiC™ FS RTLC20-S Functional Safety installation guide and safety manual
67
62
33.3
Operation
Push and release (< 3 seconds)
Push and release (> 3 seconds)
Push and hold during power 'Off/ On' cycle
6 minimum
R > 20 dynamic bend radius
1
R > 10 static bend radius
Cover plate
CAL/AGC push button switch
access hole Ø2.4
Original instructions