Table of Contents
Advertisement
DSi quick-start guide
This section is a quick-start guide to installing and calibrating a DSi system. More detailed information on installing, calibrating, and initialising a DSi is contained on pages
Complete rotation
Install and calibrate both of the TONiC encoder systems (see
Connect the TONiC encoder systems to the DSi (see
Select the correct head orientation switch position on the DSi
(see
'Readhead orientation'
Calibrate the DSi (see
Optional: Select a new propoZ reference (index) position if desired
(see
'Selecting a new reference mark output position (propoZ)'
Initialisation
(see
'Initialisation'
(Upon subsequent power-ups of the DSi)
Rotate the axis in one direction until the LED on the DSi goes solid green
(Initialisation status, 'K', goes 'high'). This may require up to 1 full turn.
The propoZ reference (index) output will now be given when the axis passes
the propoZ output position.
'System calibration'
on page 27).
'DSi connection'
on page 30).
on page 31).
'Calibration'
on page 31).
on page 33).
on page 32).
Partial rotation
IMPORTANT: Ensure the REXT ring is installed so that the reference marks are positioned
correctly, relative to the readheads (see
'Mounting the REXT (partial rotation)'
Install and calibrate each TONiC encoder system separately on their respective reference marks
(see
'System calibration'
Connect the TONiC encoder systems to the DSi (see
Select the correct head orientation switch position on the DSi (see
Calibrate the DSi (see
Optional: Select a new propoZ reference (index) position if desired
(see
'Selecting a new reference mark output position (propoZ)'
Initialisation
(see
'Initialisation'
(Upon subsequent power-ups of the DSi)
Rotate the axis to its maximum travel in both directions.
The LED on the DSi will go solid green (Initialisation status, 'K', goes 'high') when initialized.
The propoZ reference (index) output will now be given when the axis passes
the propoZ output position.
30
to 32 of this installation guide.
on page 18).
on page 27).
'DSi connection'
on page 30).
'Readhead orientation'
on page 31).
'Calibration'
on page 31).
on page 33).
on page 32).
www.renishaw.com
29
Advertisement
Table of Contents
