Table of Contents
Advertisement
Ti interface drawing
16
8
40
4-40 UNC x 2
CAL button operation
Push and release (< 3 seconds) - Calibration (CAL) routine enable/disable
Push and release (> 3 seconds) - Automatic Gain Control (AGC) enable/disable
Push and hold during power 'Off/On' cycle - Restore factory defaults
Refer to readhead LED functionality chart for CAL LED indications
*
Dynamic bend radius not applicable for UHV cables.
TONiC RESM20 angle encoder system installation guide
67
62
33.3
6 minimum
R > 20 Dynamic bend radius*
R > 10 Static bend radius
Cover plate
Dimensions and tolerances in mm
CAL/AGC push button switch
access hole Ø2.4
Diagnostic LED
(Ti0004 - Ti20KD and TD4000 - TD0040)
4
Advertisement
Table of Contents
