Lenovo ThinkSystem SD550 V3 User Manual page 92

Figure 37. Node installation to the right tray
Step 3. If there is another node or node tray fillers to install, install them now.
Important: For proper cooling, each node tray must be installed with either a node or node tray
fillers before the nodes in the chassis are powered on.
After this task is completed
1. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
53.)
2. Check the power LED to make sure it transitions between fast blink and slow blink to indicate the node
is ready to be powered on; then, power on the node.
3. Make sure that the power LED is lit continuously, indicating that the node is receiving power and is
turned on.
4. If this is the initial installation of the node into the chassis, you must configure the node through the
Lenovo XClarity Provisioning Manager and install the node operating system (see
pubs.lenovo.com/lxpm-overview/
5. If the node access over local console is not available, refer to the following sections in the XCC
documentation compatible with your node at
a. Access Lenovo XClarity Controller web interface (see "Accessing the XClarity Controller web
interface" section).
b. Set up Lenovo XClarity Controller network connection through Lenovo XClarity Provisioning Manager
(see "Setting up the XClarity Controller network connection through the XClarity Provisioning
Manager" section).
c. Log in to Lenovo XClarity Controller(see "Logging in to the XClarity Controller" section).
6. If you have changed the configuration of the node, or if you are installing a different node from the one
that you removed, make sure to configure the node through the Setup utility, and you might have to
install the node operating system. For more details, see
ThinkSystem SD550 V3 User Guide
82
"Install a hot-swap power supply" on page 63
).
https://pubs.lenovo.com/lxcc-overview/
and "Power on the node" on page
Chapter 7 "System configuration" on page
https://
.
229.