Table of Contents
Advertisement
Figure 130. Installation of the screws on the system board
Step 3.
If necessary, reinstall the cable ducts as illustrated.
Figure 131. Cable duct replacement
After this task is completed
1. Reinstall the side bracket(s) (see
2. If necessary, install the rear I/O module and rear OCP cable to the node (see
on page 180
and
"Install a power distribution board" on page
module and OCP cable to the system board (see
226).
"Install a side bracket" on page
"Rear I/O and OCP module cable routing" on page
184).
"Install a rear I/O module"
163); then, connect cables of the rear I/O
.
Chapter 5
Hardware replacement procedures
197
Advertisement
Table of Contents
Troubleshooting
