Table of Contents
Advertisement
Figure 103. PHM components
Heat sink
1
Heat sink triangular mark
2
Processor identification label
3
Nut and wire bail retainer
4
Torx T30 nut
5
Anti-tilt wire bail
6
Processor carrier
7
Clips to secure carrier to heat sink
8
Procedure
Step 1.
Make preparations for this task.
a.
Power off the node (see
from the node.
Note: If necessary, press the release clip with a flat-head screwdriver to remove an external
network cable from the rear of a 2U node.
Clips to secure processor in carrier
9
Processor ejector handle
10
Carrier triangular mark
11
Processor heat spreader
12
Thermal grease
13
Processor contacts
14
Processor triangular mark
15
"Power off the node" on page
53); then, disconnect all external cables
.
Chapter 5
Hardware replacement procedures
167
Advertisement
Table of Contents
Troubleshooting
