CAUTION:
Do not place any object on top of a rack-mounted device unless that rack-mounted device is intended
for use as a shelf.
Attention:
• Read
"Installation Guidelines" on page 43
you work safely.
• To install the rails into a rack, follow the instructions below:
https://pubs.lenovo.com/st650-v2/thinksystem_l_shaped_rail_kit.pdf
After the rails are installed successfully, complete the following steps to install the chassis to the rack.
CAUTION:
Use safe practices when lifting the chassis.
Procedure
Step 1.
Make preparations for this task.
a.
If the EIA brackets are not installed to the front of the chassis yet, install them (see
EIA brackets to the chassis" on page
Step 2.
Align the chassis with the rails; then, slide the chassis into the rack.
Step 3.
Tighten the captive screws on the front to secure the chassis to the rack.
Figure 18. Chassis installation
and
"Safety inspection checklist" on page 44
60).
Chapter 5
to make sure that
"Install the
.
Hardware replacement procedures
57