Lenovo ThinkSystem SD550 V3 User Manual page 112

About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read "Installation Guidelines" on page 43
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node and chassis; then, take the component out of the package and place it on a static-protective
surface.
Procedure
Step 1. If the drive backplane has not been installed yet, install it to the drive cage (see
backplane" on page
Step 2. Install the drive cage assembly to the node.
a. Align the cage with the triangles and guide pins on both sides of the node; then, lower the
cage into the node.
b. Connect all the required cables to the drive backplane (see
routing" on page
c. Push the cage toward the rear of the node until all the screw holes are aligned.
d. Tighten the eight screws as illustrated to secure the cage.
ThinkSystem SD550 V3 User Guide
102
and "Safety inspection checklist" on page 44
100).
215).
to make sure that
"Install a drive
"2.5-inch drive backplane cable