Lenovo ThinkSystem SD550 V3 User Manual page 143

2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install an M.2 drive
Follow instructions in this section to install an M.2 drive.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read "Installation Guidelines" on page 43
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node and chassis; then, take the component out of the package and place it on a static-protective
surface.
Procedure
Step 1. Locate the M.2 connectors on the system board. Then, determine to which connector the M.2 drive
is to be installed.
Figure 78. Location of the M.2 bays on the system board
M.2 bay 0
1
Step 2. Install the M.2 drive to the system board.
a. Insert the M.2 drive into the M.2 connector at an angle of approximately 15 degrees.
b. Slightly press the retainer to accommodate the M.2 drive.
c. Pivot and press down the M.2 drive; then, make sure the M.2 drive is engaged securely by
the retainer.
and "Safety inspection checklist" on page 44
M.2 bay 1
2
Chapter 5
to make sure that
.
Hardware replacement procedures
133