Paradyne 7974 User Manual page 128

A. Configuration Options
Table A-11. Communication Protocol Options (1 of 2)
A-24
Node IP Address
Possible Settings: 001.000.000.000 – 223.255.255.255
Default Setting: 000.000.000.000
Specifies the Node IP address. The IP address is not bound to a particular port, and can
be used for remote access over the EOC.
T
Node IP Address is only available when the unit is configured as an LTU. It does not
appear when the unit is connected to a DSLAM card running in IP Conservative
mode.
001.000.000.000 – 223.255.255.255 – Enter an IP address for the node. The range for
the first byte is 001 to 223, with the exception of 127. The range for the remaining three
bytes is 000 to 255.
Clear – Clears the IP address field to all zeros.
Node Subnet Mask
Possible Settings: 000.000.000.000 – 255.255.255.255
Default Setting: 000.000.000.000
Specifies the Node Subnet Mask.
T
Node Subnet Mask is only available when the unit is configured as an LTU. It does
not appear when the unit is connected to a DSLAM card running in IP Conservative
mode.
000.000.000.000 – 255.255.255.255 – Enter an address for the Node Subnet Mask.
Clear – Clears the mask to all zeros.
Default Network Destination
Possible Settings: None, COM, DSL
Default Setting: None
Specifies where the default management network is connected. For example, if your
default network is connected to the COM port, select COM as the default management
network destination.
None – No default destination is defined. Data that cannot be routed is discarded.
COM – The unit's COM port is the default network destination.
T
COM is only available when the Port Use option on the Communication Port
Options menu is set to Net Link.
DSL – The unit's DSL port is the default network destination.
December 2001 7900-A2-GB21-20