IP Addressing
Selecting an IP Addressing Scheme
Configurations Not Running IP Conservative Software
All Configurations
7970-A2-GB20-00
Your IP addressing scheme depends in part whether the Hotwire 79xx
Standalone Termination Unit is running in IP Conservative mode. The unit runs in
IP Conservative mode if it is connected to a DSLAM card running in IP
Conservative mode.
For a configuration not running IP Conservative software, the NTU's network
interface IP address is assigned through the peer IP address of the LTU's
Network Interface menu.
The termination unit is assigned an IP address and subnet through the DSLAM
Configuration
DSL Cards
assigned, you can use the ATI to assign:
H
Peer IP address. This address is used as the IP address of the remote unit.
See Table A-1,
Network Interface
Option Tables .
H
An IP address for each NMS to act as a trap manager. See Table A-11,
SNMP Traps
Options, in Appendix A, Configuration Option Tables .
The NTU obtains its IP address when the PPP link is established over the EOC.
Use the ATI to assign:
H
An IP address for each NMS. See Table A-10,
in Appendix A, Configuration Option Tables .
H
An IP address for the TFTP server you wish to use to upload and download
configurations. See
Configuration Loader
Configuration , and the documentation for your TFTP server.
August 1999
Set IP Address menu. Once the address is
Options, in Appendix A, Configuration
SNMP NMS Security
in Chapter 3, Initial Startup and
9
Options,
9-1