Paradyne 7974 User Manual page 36

3. Initial Startup and Configuration
3-12
2. Position the cursor in the TFTP Server IP Address field. Enter the TFTP server
IP address.
3. Position the cursor in the Destination field. Use the spacebar to select a
network destination for the TFTP server. Select DSL if the TFTP server
destination is the DSL link or COM if the TFTP destination is the COM port.
4. Position the cursor in the TFTP Transfer Direction field. Use the spacebar to
select Download from Server or Upload to Server.
5. Position the cursor at the Start Transfer field. Use the spacebar to select Yes.
Press Enter.
When the data transfer is complete, the Transfer Status field changes to
Completed successfully.
6. Position the cursor at the Activate new configuration? prompt and
select Yes to activate a new downloaded configuration. Press Enter.
NOTE:
Configuration options DSL Mode and Telnet Session are not changed when a
new configuration is loaded. You must change these settings with the
appropriate configuration menus after the new configuration is activated. See
Table A-8, System Options, and
Appendix A, Configuration Options .
December 2001
Table A-10, Telnet Session Options, in
7900-A2-GB21-20