Paradyne 7974 User Manual page 123

Table A-9. Communication Port Options (2 of 3)
7900-A2-GB21-20
Parity
Possible Settings: None, Odd, Even
Default Setting: None
Specifies the parity of the communication port.
T
Parity only appears when Port Use is set to Terminal.
None – No parity used.
Odd – Odd parity used.
Even – Even parity used.
Stop Bits
Possible Settings: 1, 1.5, 2
Default Setting: 1
Specifies the number of stop bits for the communication port.
T
Stop Bits only appears when Port Use is set to Terminal.
1 – One stop bit.
1.5 – One and one half stop bits.
2 – Two stop bits used.
Ignore Control Leads
Possible Settings: Disable, DTR
Default Setting: Disable
Specifies whether DTR is used.
T
Ignore Control Leads only appears when Port Use is set to Terminal.
Disable – Control leads are treated as standard.
DTR – DTR is ignored.
Login Required
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies if an ID and password are required to access the asynchronous terminal
interface on the communication port. Login IDs are created with a password and access
level. Refer to Creating a Login
T
Login Required only appears when Port Use is set to Terminal.
Enable – Login ID and password are required to access the asynchronous terminal
interface.
Disable – No Login ID and password are required to access the asynchronous terminal
interface.
December 2001
in Chapter 6, Security .
A. Configuration Options
A-19