Emerson Rosemount Ultrasonic 3810 Series Instructions Manual page 22

Install
February 2024
20. Wrap the excess cable around the Acquisition Module and place the electronics
21. Ensure the O-ring on the base of the upper enclosure is properly seated. Position
22. Install the 3810 meter upper enclosure on the base enclosure once the transducers
23. Install the two screws with the 6 mm Allen wrench to secure the upper enclosure to
22
Figure 2-12: Installing the Acquisition Cable and Module
A. Acquisition cable connector
B. Acquisition cable
C. Cable clamp and screw
housing into position on the base enclosure.
the upper enclosure housing so that it is in the desired orientation for reattaching
the electrical conduit.
are wired correctly.
the base enclosure.
Upgrade kit instructions
00825-0200-3810
3810 Series Electronics