Removing 3800 Series Electronics - Emerson Rosemount Ultrasonic 3810 Series Instructions Manual

Plan
February 2024
1.4

Removing 3800 Series Electronics

1.4.1 Procedure to remove the 3800 Series Electronics
Procedure
1. Having obtained all the information related to the set-up of the 3800 Series
2. Remove any conduit and wiring attached to all six conduit ports.
3. Remove any ground wire attached to the ground lug on the outside of the upper
4. Use the 6 mm Allen wrench (supplied with kit) to remove the two bolts holding the
12
electronics configuration and communications, all the components related to the
electronics can now be physically removed from the meter. Unscrew all wiring from
the Field Termination Board. It may be helpful to label the wires to make it easier to
connect the 3810 Series electronics.
electronics housing. At this point there should be no wires connected to the upper
electronics housing.
Figure 1-7: Ground Wire Removed
base enclosure.
Upgrade kit instructions
00825-0200-3810
3810 Series Electronics