Table of Contents
Advertisement
Install
February 2024
9. Route the transducer cables through the cable glands with the correct label number
10. Judge the proper length and cut off the excess.
11. Strip the outer insulation, outer shield, and inner insulation using a utility knife.
18
Figure 2-6: Acquisition Module Wiring
A. Acquisition Module A1 transducer wiring
B. Base enclosure A1 transducer port
(i.e. A1) which matches the label on the transducer cable.
Figure 2-7: Base Enclosure Cable Glands Installation
Verify that insulation of individual wires was not cut while removing outer layers.
Strip each wire 0.28-in.
Upgrade kit instructions
00825-0200-3810
3810 Series Electronics
Advertisement
Table of Contents
