Emerson Rosemount Ultrasonic 3810 Series Instructions Manual page 13

Upgrade kit instructions
00825-0200-3810
5. Remove the upper electronics housing from the base enclosure.
6. Remove all the screws that hold the transducer wires in the terminal blocks that
Emerson.com
Figure 1-8: Remove Bolts from Base Enclosure Cover
a) Remove the Acquisition cable, which comes down from the upper electronics
to the Acquisition module in the base enclosure.
NOTICE
Figure 1-9 shows the Acquisition module for the 3400 Series electronics.
b) Loosen the two screws on the ends of the Acquisition cable connector, and
disconnect it from the Acquisition module.
c) Set the upper electronics housing aside once the housing is removed.
Figure 1-9: Remove the Acquisition Cable
attach the transducers to the Acquisition module.
a) Remove the screws from the ends of the two connectors.
Plan
February 2024
13