Espressif ESP32-S2 Programming Manual page 477

Chapter 2. API Reference
• parity_mode: Pointer to accept value of UART parity mode.
esp_err_t uart_set_baudrate(uart_port_t
Set UART baud rate.
Return
• ESP_FAIL Parameter error
• ESP_OK Success
Parameters
• uart_num: UART port number, the max port number is (UART_NUM_MAX -1).
• baudrate: UART baud rate.
esp_err_t uart_get_baudrate(uart_port_t
Get the UART baud rate configuration.
Return
• ESP_FAIL Parameter error
• ESP_OK Success, result will be put in (*baudrate)
Parameters
• uart_num: UART port number, the max port number is (UART_NUM_MAX -1).
• baudrate: Pointer to accept value of UART baud rate
esp_err_t uart_set_line_inverse(uart_port_t
Set UART line inverse mode.
Return
• ESP_OK Success
• ESP_FAIL Parameter error
Parameters
• uart_num: UART port number, the max port number is (UART_NUM_MAX -1).
• inverse_mask: Choose the wires that need to be inverted.
uart_signal_inv_t
esp_err_t uart_set_hw_flow_ctrl(uart_port_t
Set hardware flow control.
Return
• ESP_OK Success
• ESP_FAIL Parameter error
Parameters
• uart_num: UART port number, the max port number is (UART_NUM_MAX -1).
• flow_ctrl: Hardware flow control mode
• rx_thresh: Threshold of Hardware RX flow control (0 ~ UART_FIFO_LEN). Only when
UART_HW_FLOWCTRL_RTS is set, will the rx_thresh value be set.
esp_err_t uart_set_sw_flow_ctrl(uart_port_t
Set software flow control.
Return
• ESP_OK Success
• ESP_FAIL Parameter error
Parameters
• uart_num: UART_NUM_0, UART_NUM_1 or UART_NUM_2
• enable: switch on or off
• rx_thresh_xon: low water mark
• rx_thresh_xoff: high water mark
esp_err_t uart_get_hw_flow_ctrl(uart_port_t
Get the UART hardware flow control configuration.
Return
• ESP_FAIL Parameter error
Espressif Systems
uart_num, uint32_t baudrate)
uart_num, uint32_t *baudrate)
uart_num, uint32_t inverse_mask)
uart_num,
rx_thresh)
uart_num, bool enable, uint8_t rx_thresh_xon, uint8_t
rx_thresh_xoff)
uart_num, uart_hw_flowcontrol_t
466
Submit Document Feedback
Using the ORred mask of
uart_hw_flowcontrol_t flow_ctrl, uint8_t
*flow_ctrl)
Release v4.4