Espressif ESP32-S2 Programming Manual page 105

Chapter 2. API Reference
Return
• ESP_OK: succeed
• ESP_ERR_WIFI_NOT_INIT: WiFi is not initialized by esp_wifi_init
• ESP_ERR_INVALID_ARG: invalid argument
Parameters
• [out] en: store the current status of promiscuous mode
esp_err_t esp_wifi_set_promiscuous_filter(const
Enable the promiscuous mode packet type filter.
Note The default filter is to filter all packets except WIFI_PKT_MISC
Return
• ESP_OK: succeed
• ESP_ERR_WIFI_NOT_INIT: WiFi is not initialized by esp_wifi_init
Parameters
• filter: the packet type filtered in promiscuous mode.
esp_err_t esp_wifi_get_promiscuous_filter(wifi_promiscuous_filter_t
Get the promiscuous filter.
Return
• ESP_OK: succeed
• ESP_ERR_WIFI_NOT_INIT: WiFi is not initialized by esp_wifi_init
• ESP_ERR_INVALID_ARG: invalid argument
Parameters
• [out] filter: store the current status of promiscuous filter
esp_err_t esp_wifi_set_promiscuous_ctrl_filter(const
Enable subtype filter of the control packet in promiscuous mode.
Note The default filter is to filter none control packet.
Return
• ESP_OK: succeed
• ESP_ERR_WIFI_NOT_INIT: WiFi is not initialized by esp_wifi_init
Parameters
• filter: the subtype of the control packet filtered in promiscuous mode.
esp_err_t esp_wifi_get_promiscuous_ctrl_filter(wifi_promiscuous_filter_t
Get the subtype filter of the control packet in promiscuous mode.
Return
• ESP_OK: succeed
• ESP_ERR_WIFI_NOT_INIT: WiFi is not initialized by esp_wifi_init
• ESP_ERR_WIFI_ARG: invalid argument
Parameters
• [out] filter: store the current status of subtype filter of the control packet in promiscuous
mode
esp_err_t esp_wifi_set_config(wifi_interface_t
Set the configuration of the ESP32 STA or AP.
Attention 1. This API can be called only when specified interface is enabled, otherwise, API fail
Attention 2. For station configuration, bssid_set needs to be 0; and it needs to be 1 only when users need to
check the MAC address of the AP.
Attention 3. ESP32 is limited to only one channel, so when in the soft-AP+station mode, the soft-AP will
adjust its channel automatically to be the same as the channel of the ESP32 station.
Return
• ESP_OK: succeed
• ESP_ERR_WIFI_NOT_INIT: WiFi is not initialized by esp_wifi_init
• ESP_ERR_INVALID_ARG: invalid argument
• ESP_ERR_WIFI_IF: invalid interface
• ESP_ERR_WIFI_MODE: invalid mode
• ESP_ERR_WIFI_PASSWORD: invalid password
Espressif Systems
interface, wifi_config_t
94
Submit Document Feedback
wifi_promiscuous_filter_t *filter)
*filter)
wifi_promiscuous_filter_t
*filter)
*conf)
*filter)
Release v4.4