Espressif ESP32-S2 Programming Manual page 313

Chapter 2. API Reference
esp_err_t i2s_set_clk(i2s_port_t
Set clock & bit width used for I2S RX and TX.
Similar to i2s_set_sample_rates(), but also sets bit width.
1. stop i2s;
2. calculate mclk, bck, bck_factor
3. malloc dma buffer;
4. start i2s
Return
• ESP_OK Success
• ESP_ERR_INVALID_ARG Parameter error
• ESP_ERR_NO_MEM Out of memory
Parameters
• i2s_num: I2S port number
• rate: I2S sample rate (ex: 8000, 44100...)
• bits_cfg: I2S bits configuration the low 16 bits is for data bits per sample in one channel (see
'i2s_bits_per_sample_t' ) the high 16 bits is for total bits in one channel (see'i2s_bits_per_chan_t'
) high 16bits =0 means same as the bits per sample.
• ch: I2S channel, (I2S_CHANNEL_MONO, I2S_CHANNEL_STEREO or specific channel in
TDM mode)
float i2s_get_clk(i2s_port_t
get clock set on particular port number.
Return
• actual clock set by i2s driver
Parameters
• i2s_num: I2S port number
Structures
struct i2s_pin_config_t
I2S pin number for i2s_set_pin.
Public Members
int mck_io_num
MCK in out pin
int bck_io_num
BCK in out pin
int ws_io_num
WS in out pin
int data_out_num
DATA out pin
int data_in_num
DATA in pin
struct i2s_driver_config_t
I2S driver configuration parameters.
Public Members
i2s_mode_t mode
I2S work mode
uint32_t sample_rate
I2S sample rate
Espressif Systems
i2s_num, uint32_t rate, uint32_t bits_cfg,
i2s_num)
302
Submit Document Feedback
i2s_channel_t ch)
Release v4.4