Table of Contents
Advertisement
™
Carestation
620/650/650c (A1)
3-18
3.
Select Patient to have spirometry data sourced from the airway
module or Vent to have spirometry data sourced from the
ventilator.
Note
When using the Airway Gas Option, only Vent is available for the
Data Source.
Note
If no airway module is installed, all settings will default back to Vent.
4.
Select Back to view changes made and access other functions
of the Spirometry menu.
Setting sweep speed
Use the Sweep Speed setting to set the waveform draw rate to fast
(6.25 mm/s) or slow (0.625 mm/s). When the sweep speed changes,
waveforms redraw at the new rate.
1.
Select System Setup - Screen Setup.
2.
Select More Settings.
3.
Select Sweep Speed and then select Fast or Slow.
4.
Select Close.
Setting display brightness
Use the brightness setting to adjust the contrast level of the display.
1.
Select System Setup - Screen Setup.
2.
Select More Settings.
3.
Select Display Brightness.
4.
Select the desired brightness level with 1 being the dimmest and
5 being the brightest.
5.
Select Close.
Setting keypad brightness
Use the brightness setting to adjust the contrast level of the hard
keys on the bezel.
1.
Select System Setup - Screen Setup.
2.
Select More Settings.
3.
Select Keypad Brightness.
4.
Select the desired brightness level with 1 being the dimmest and
5 being the brightest.
Set to 0 to turn off the keypad brightness.
5.
Select Close.
2076152-001
Advertisement
Table of Contents
