2.3.2 Mounting The Device To A Panel - Siemens SIMATIC NET RUGGEDCOM RSG920P Equipment Manual

3.
4.
Removing the Device
To remove the device from a DIN rail, do the following:
1.
2.
3.
2.3.2 Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RSG920P can be equipped with panel
adapters that allow the device to be attached to a panel in multiple orientations.
Note
A side mount orientation requires additional adapters.
RUGGEDCOM RSG920P
Equipment Manual, 10/2023, C79000-G8976-1172-09
Panel/DIN Rail Adaptor
2
Figure 2.2 Mounting the Device to a DIN Rail
Insert a flathead screwdriver into the slot of the sliding release and move it
down.
Push the device against the bottom of the DIN rail, then let go of the sliding
release to latch the device.
Insert a flathead screwdriver into the slot of the sliding release and move it
down.
3
1
2
1
DIN Rail
1
DIN Rail Adapter
2
Figure 2.3 Removing the Device from a DIN Rail
Swing the bottom of the device away from the DIN rail.
Lift the device off the DIN rail.
2.3.2 Mounting the Device to a Panel
1
2
Installing the Device
11