Decommissioning And Disposal; Cabling Recommendations - Siemens SIMATIC NET RUGGEDCOM RSG920P Equipment Manual

Introduction
1.4 Decommissioning and disposal
4 x #8-32 screws
1.4

Decommissioning and disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated "RUGGEDCOM ROS Configuration
Manual".
Recycling and disposal
This device is low in pollutants, can be recycled, and meets the requirements of the
WEEE directive 2012/19/EU for the disposal of electrical and electronic equipment.
Do not dispose of devices at public disposal sites.
For environmentally friendly recycling and the disposal of devices, contact a certified
disposal company for electronic scrap or your Siemens contact.
For more information, refer to
view/109479891.
Note the different national regulations.
1.5

Cabling Recommendations

The IEEE 802.3ab Gigabit Ethernet standard defines 1000 Mbps Ethernet
communications over distances of up to 100 m (328 ft) using all 4 pairs in category
5 (or higher) balanced, unshielded twisted-pair cabling. For wiring guidelines,
system designers and integrators should refer to the Telecommunications Industry
Association (TIA) TIA/EIA-568-A wiring standard that characterizes minimum cabling
performance specifications required for proper Gigabit Ethernet operation. For
4
Tools/Materials
https://support.industry.siemens.com/cs/ww/en/
Purpose
For mounting the device to a panel.
Equipment Manual, 10/2023, C79000-G8976-1172-09
RUGGEDCOM RSG920P