Chapter 2
Installing the Device
1
2
Figure 3: DIN Rail Mounting
1. DIN Rail 2. Panel/DIN Rail Adapter 3. Screw
2.
Install one of the supplied screws on either side of the device to secure the adapters to the DIN rails.
Section 2.3.3
Mounting the Device to a Panel
For panel installations, the RSG2488F can be ordered with panel/DIN rail adapters pre-installed on each side of the
chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1.
Place the device against the panel and align the adapters with the mounting holes.
10
3
1
2
RUGGEDCOM RSG2488F
Installation Guide
Mounting the Device to a Panel