Table of Contents
Advertisement
For safety, remove the emergency
stop switch clip so the engine cannot
be started while you are standing near
the propeller.
1. Disconnect the fuel hose from the
outboard motor.
2. Tilt down the outboard motor.
3. Clean and wash the outside of the
outboard motor with fresh water.
FLUSH PORT
CONNECTOR
4. Disconnect the flush port
connector.
GARDEN HOSE
FLUSH PORT
CONNECTOR
GARDEN HOSE JOINT
(Commercially available)
5. Screw the flush port connector onto
the garden hose.
6. Turn on the fresh water supply and
flush the outboard motor for at
least 10 minutes.
Check that water is draining from
the cooling system indicator, the
cooling water intake port and the
exhaust port.
Do not start the engine while
flushing.
CLEANING AND FLUSHING
COOLING WATER INTAKE
PORT
EXHAUST PORT
7. After flushing, disconnect the
garden hose and reconnect the flush
port connector.
8. Tilt up the outboard motor and
move the tilt lock lever to the
LOCK position.
119
Advertisement
Table of Contents
