HONDA marine BF115J Owner's Manual page 116

SERVICING YOUR OUTBOARD MOTOR
6. Thoroughly clean the cup, and
replace with a new fuel filter.
7. Reassemble the fuel filter with
water separator in the reverse order
of removal. Use a new O-ring.
TIGHTENING TORQUE:
2.5 lbf·ft (3.4 N·m, 0.35 kgf·m)
114
SCREW
ALIGNING SUSPENSION
MARK STRAP
8. Position the aligning mark as
shown in the figure when
installing the suspension strap on
the fuel filter with water separator.
9. Prime the engine using the
priming bulb (p.62). Check for fuel
leaks. Repair any fuel leaks if
necessary.
If the buzzer sounds or water or
sediment accumulation is found in the
fuel filter with water separator,
inspect the fuel tank.
Clean the fuel tank and tank filter if
necessary. It may be necessary to
drain the fuel tank completely and
refill with fresh gasoline.