Table of Contents
Advertisement
OPERATION
ONE-LEVER MODE
(For multiple outboard motors
type)
SYNC
INDICATOR
Shifting gear and the engine speed
adjustment of the all outboard motors
can be performed with one remote
control lever when in one-lever
mode.
If you press and hold the [+] switch
when all remote control lever is in the
NEUTRAL position, the mode
changes to one-lever mode.
A long buzz sounds once and SYNC
indicator comes on.
88
SHALLOW WATER
OPERATION
When operating in shallow water, use
the power trim/tilt switch (p. 83) to
tilt the outboard motor so that the
propeller and gear case won't hit the
bottom.
Proceed at low speed, and monitor
water flow from the cooling system
[+] SWITCH
indicator (p. 57) to be sure the
outboard motor is not tilted so high
that the water intakes are out of the
water.
An excessive trim/tilt angle during
operation can cause propeller
ventilation, overheating, and water
pump damage. This type of damage is
not covered by the Distributor's
Limited Warranty (U.S.) /
Distributor's Warranty (CA.) (p. 152).
68°
12°
TILT
0°
ANGLE
– 4°
16°
0°
(VERTICAL LINE)
TRIM ANGLE
(when transom angle is 12°)
Advertisement
Table of Contents
