Section 4: Changing The Room Set Point - Nailor 35SW Manual

Section 4: Changing the Room Set Point
This section covers topics for the end user.
Changing the EZvav user functions with an STE-8001W36 or STE-8201W36 are limited to changing the active set points in a room.
The set points are entered or changed using the buttons and display on the front of the sensor.
Quick start to changing set points
1. Press any button to begin changing set points.
2. If required, enter Password 1.
∆
3. Press the up
4. Press the button to save the value or advance to the next function.
To enter or change the active set points you may need Password 1 .
Tip: Once the following procedure is started, all steps must be completed in order.
Changing Room Set Points
PROCEDURE
1 Starting display
2 Enter Password 1
3 Set the active cooling set point.
4 Set the active heating set point.
Date: 10-2016 Supersedes: 7-2016
Nailor reserves the right to change any information concerning product or specification without notice or obligation.
Installation and Operation Manual
∆
or down buttons to change a set point value.
Start from the temperature display.
1. Press any button. The display changes to PSW1.
∆
2. Press the
3. Press the
for all four digits.
Note: If Password 1 has not previously been entered,
the display will change to the occupied cooling set point
display after Step 1.
∆
1. Press the
set point temperature. The set point changes in
increments of 0.5 degrees.
2. Press the
The display advances to set the heating set point.
∆
1. Press the
set point temperature. The set point changes in
increments of 0.5 degrees.
2. Press the
The display returns to the temperature display.
EZvav Digital Controls
●
STEPS
or buttons to change the first digit.
button to select the next digit. Repeat
or buttons to change the cooling
button to save the value.
or buttons to change the heating
button to save the value.
Page 13 of 48
STE DISPLAY

3
237
////

#//,).'

(%!4).'
IOM-EZVAVINST