Setup Menu Options; Obtaining And Updating Licenses - Xerox DocuPrint 100MX User Manual

Setup menu options

IPS Gateway User's Guide (5/2002)
These options are available from the Setup drop-down menu:
• License
• Security
NOTE: You must be logged on as System Administrator to access the
Setup menu options.

Obtaining and updating licenses

When obtaining new software licenses, be prepared to provide the printer
controller (Sun workstation) host ID number and printer engine serial
number. To retrieve the 8-character hexadecimal hostid number, open a
terminal window and enter hostid at the prompt.
These licenses are required for IPS Gateway to operate:
• IPS Gateway
• PostScript Decomposer
• SNMP Gateway
• TCP/IP Socket Gateway
• IPS/NPS
The IPS Gateway and IPS/NPS software licenses are normally delivered
with the IPS Gateway software. Enter or change your license if IPS
Gateway is operating in a disabled mode (no license is loaded) or if your
IPS Gateway and/or IPS/NPS software license has expired.
NOTE: Sixty days prior to your IPS/NPS software license expiring, a
daily message displays in the IPS Gateway fault message area
showing the number of days to expiration. Contact your local Xerox
representative to obtain a valid license.
Until a valid license string and expiration date are entered, IPS Gateway
cannot receive IPDS data from the host. You can access and perform
tasks such as specifying setup parameters, but IPS Gateway remains in
an "IPDS Not Ready" state.
For instructions on entering or changing a license, go to the appropriate
section or document listed in the table below.
IPS Gateway
IPS/NPS
SNMP Gateway
TCP/IP Socket Gateway
PostScript Decomposer
License
Licensing and enabling IPS Gateway
Licensing and enabling IPS/NPS
DocuSP System Guide
IPS Gateway operation
Go to
3-5