Installing The Software - Xerox DocuPrint 100MX User Manual

Installing the software

IPS Gateway User's Guide (5/2002)
This section provides instructions for installing IPS Gateway on a
DocuPrint controller workstation. The installation program removes any
previously installed version of this software before it installs the new
version.
NOTE: If installing over any version of IPS Gateway, document your
IPS Gateway settings and passwords. They will not be saved when
the software is removed.
To install the IPS Gateway software:
Step 1. Place the IPS Gateway CD into the CD-ROM drive.
Step 2. If Volume Manager is running on your workstation, a window labeled "File
Manager - cdrom" appears on the desktop. Close the File Manager -
cdrom window.
Step 3. Open a terminal window and change to this directory, or to wherever your
CD-ROM directory resides, by entering this command:
cd /cdrom/cdrom0
Step 4. Enter this command to start the installation program:
./install.sh
Step 5. You are asked if you want to continue with the installation. Enter y to
continue with the installation or n to cancel the installation procedure.
If you enter "n," the installation stops and you are returned to a command
prompt on the terminal window. IPS Gateway is not installed.
Step 6. When prompted, enter the root password.
Step 7. If a previous version of the software is installed, the program asks you to
confirm that you want to remove the currently installed version. Enter y to
remove the previous version and install the new version. The program
begins installing the IPS Gateway packages.
NOTE: Any previous IPS/NPS license is retained in the newly
installed version.
If you enter "n," the installation stops and you are returned to a command
prompt on the terminal window. The new version of IPS Gateway is not
installed.
Installation and setup
2-4