Setting Up Media In Docusp; Mapping Ipds Trays To Media Definitions - Xerox DocuPrint 100MX User Manual

IPS Gateway User's Guide (5/2002)

Setting up media in DocuSP

In DocuSP, define and load the media required to run your job(s). Refer
to the DocuSP System Guide for instructions on defining media. All media
defined in DocuSP, including custom sizes, are supported by IPS
Gateway.

Mapping IPDS trays to media definitions

The Media Setup tab allows you to map a specific medium to each
possible IPDS Tray Selection Value in the IPDS data stream. Each
specified IPS Gateway medium must already be defined correctly in the
DocuSP Printer Manager and loaded in that tray. For IPS Gateway, there
are eight possible IPDS Tray Selection Values (1 through 8).
When IPS Gateway receives the IPDS Tray Selection Value for the IPDS
page it is composing, it sends the medium specification currently defined
for that IPDS tray to DocuSP, which uses the stock specification to
determine which physical tray to pull from.
For an IPS Gateway job, if the requested IPDS tray is mapped to medium
not assigned to a physical tray in DocuSP:
• The job displays as ineligible in DocuSP and does not print
• The invalid media definition displays in red on the IPS Gateway
Media Setup tab
NOTE: If media is changed in the DocuSP Printer Manager, the IPDS
media setup in IPS Gateway must be updated to reflect the valid
media definition(s).
If you define custom paper sizes in DocuSP, the actual dimension is listed
in the Media Definition drop-down in the IPS Gateway Media Setup tab,
instead of the Size name. This table provides the dimensions for some
common paper sizes.
Paper size
US Letter
US Legal
US Ledger
A3
A4
US Statement
IPS Gateway operation
Inches
8.50 x 11.00 216 x 279
8.50 x 14.00 216 x 356
17.00 x 11.00 432 x 279
16.54 x 11.69 420 x 297
8.27 x 11.69 210 x 297
5.50 x 8.50 140 x 216
Millimeters
3-18