Stapling - Xerox DocuPrint 100MX User Manual

IPS Gateway User's Guide (5/2002)

Stapling

The Stapling option allows you to specify stapling for your print jobs. By
selecting a stapling mode, all jobs between 2 and 50 pages are stapled.
Not all IPDS finishing options may be available for your printer. In
addition, it you use this option, DocuSP must also have stapling enabled.
For available finishing options and to enable stapling on DocuSP, refer to
the DocuSP System Guide.
NOTE: Offset job stacking is not supported when using the Stapling
option.
To specify stapling:
Step 1. From the drop-down box in the Stapling area, select one of these stapling
options:
• None — Indicates no stapling.
• StackerOffset — Staples when an IPDS XOA Alternate Offset
Stacker command is received. When printing multiple copies, a job
containing three copies of a five page job staples each of the five
page sets individually.
• MarkForm — Staples at the MarkForm page boundary. When printing
multiple copies, a job containing three copies of a five page job is
stapled as one set.
• Defined Group Boundary — Staples based upon host controlled
finishing specified within the group boundary orders of the IPDS job.
Select this option to give the host control of all stapling options for
your jobs. Job-specified stapling is honored.
Step 2. Click Save to save your setting and reset IPDS as indicated; see
"Important setup instructions" for more information.
IPS Gateway operation
3-15