Y34-Last Lf On Page Sent As Ff; Y36-Suppress Ibm Control Code - Xerox 4215 Reference Manual

Y34—Last LF on Page Sent as FF
Y36—Suppress IBM Control Code
XEROX MRP FAMILY COAX COMMAND REFERENCE
@@Y34, n@
Decides whether the last line feed on a page should be sent as a
Form Feed or a line feed. This option, when enabled, counts the
number of lines and generates a form feed when the line count
equals the page length. Calculations are based on the page
length, which can be set at the printer and overridden by the
appropriate IBM command when operating in the SCS mode.
n
The default is product dependent. Use 0 as the default for non
page printers. Use 1 as the default for page printers, and when
printing in duplex, and in conjunction with pending page layout
(page boundary) select. All Line Feeds preceding this Form Feed
command are suppressed.
Example @Y34, 1@ sends last LF as FF.
@Y36, n@
Suppresses all or some IBM control codes sent from the host
system.
n
If you decide to select n = 1, Suppress IBM control codes, you
need to format documents by the sending of transparent control
codes.
FUNCTION SELECTION VIA LINE (FSL) COMMANDS
Values for n are:
0* No (option disabled)
1* Yes (option enabled), counts the lines
when you use Function Y5—Set Default
Page Length (MPL); and SCS Set Vertical
Format (SVF) command.
Values for n are:
0* Respect all IBM control codes
1 Suppress all IBM control codes.
2 Suppress SCS pitch and line density
commands (CPI and LPI). This value is
reserved and is used only because of
compatibility with old products.
3-35