Graphic Escape (Ge); Horizontal Tab (Ht); Inhibit Print (Inp) - Xerox 4215 Reference Manual

Graphic Escape (GE)

Horizontal Tab (HT)

Inhibit Print (INP)

XEROX MRP FAMILY COAX COMMAND REFERENCE
Remember For the 3812 emulation, if the maximum page length is set to
•
1, the Form Feed command causes a new line to occur. Any
other page length causes the printer to eject the current
page on receipt of a form feed.
You should not use the New Line command when moving
•
the print position from one form to the next.
08gg
Allows A Programming Language (APL) characters to be sent in a
SCS data stream. Each APL character in the data stream is
preceded by a GE.
08
gg
When GE is supported and is followed by another control code
(X'00' through X'3F' and X'FF'), the two bytes (08gg) are treated
as one invalid SCS command and cause a single "function not
supported" response to the application program. X'00' through
X'3F' are unprintable.
05
Moves the print position to the right one tab stop setting. If no
tab stop is detected or the last tab stop is to the left of the
current print position, a movement to the right by one space is
executed, and an error code 2 appears. If an HT is requested
after passing the right margin, a new line is created and a space
is printed at the left margin.
05
24
This command is used in conjunction with the Enable Print (EP)
command. Printable characters between INP and ENP are
translated to blanks. SCS control codes between INP and ENP
can cause unpredictable results.
Note: Only the 4245 emulation carries out the actions described
N
above. All other emulations ignore this command.
24
DSC AND SCS DATA STREAM COMMANDS
Control sequence of a Graphic Escape command
Single-byte character between X'40' and X'FE'
that defines the APL code point for the character.
Control sequence of a Horizontal Tab command
Control sequence of an Inhibit Print command
2-9