Y8-Set Lu1 Language - Xerox 4215 Reference Manual

Y8—Set LU1 Language
XEROX MRP FAMILY COAX COMMAND REFERENCE
FUNCTION SELECTION VIA LINE (FSL) COMMANDS
@Y8, n@
Selects the LU1 language translate table at power up, and has
effect as soon as it is received.
The factory default setting is 00. If the conversion table is not
loaded, then 01 is used as default.
n Valid parameters are:
00*
1
3
4
5
6
7
8
9
10
11
12
13
14
15
16
19
20
21
22
23
24
25
26
27
28
30
31
32
40
If the number is not defined in the printer, it is ignored. The
code point for the FSL ESC character is not reset after using this
function. This causes problems if the FSL ESC character is
national dependent.
The codepoint for the FSL Single Paired Hex Transparent, ESC
character, is not reset after using this FSL function Y8. This may
cause problems if the FSL ESC character is national dependent.
If n is not defined in the printer, FSL Y8 is ignored.
Download LU1 language from 3174
control unit or 3274 (configuration
support C or D only)
English (U.S.) EBCDIC
Austria/Germany
Belgium
Brazilian
Canadian (French)
Danish/Norwegian
Danish/Norwegian (Alternate)
Finnish/Swedish
Finnish/Swedish (Alternate)
French
French (Use 11 French.)
Austrian/German (Alternate)
International
Italian
Japanese (English)
Spanish
Spanish (Alternate)
Spanish speaking
English (UK)
Norwegian (Use 7 Danish/Norwegian.)
Swedish (Use 9 Finnish/Swedish.)
EBCDIC WT (Use 1 English (U.S.)
EBCDIC.)
Norwegian Alt (Use 8 Danish/Norwegian
Alternate.)
Swedish Alt (Use 10 Finnish/Swedish
Alternate.)
Portuguese
French 105-character
Swiss-German/Swiss-French
Swiss-French (Use 31 Swiss-German/
Swiss French.)
Spanish Data Text/Extension
3-17