Set Print Density (Spd) - Xerox 4215 Reference Manual

Set Print Density (SPD)

XEROX MRP FAMILY COAX COMMAND REFERENCE
2BD2nn2900cp
Defines the number of characters to print per horizontal inch
(CPI) or characters per line (CPL).
2B Control sequence prefix of a Set Print Density
command
D2 Command class for Set Print Density
nn Number of bytes in a command string including
the byte count
Valid nn are:
02 =
04 =
Any other values cause the default value of CPI,
that is set at the printer, to be used and an
invalid SCS parameter check occurs.
29 Control type for Set Print Density command
00 One-byte number which must be X'00.'
cp One-byte number expressed in hexadecimal that
specifies a CPI value for the emulations as
follows:
00 = 10 CPI
0A = 10 CPI
0C = 12 CPI
0F = 15 CPI
10 = 16.6 CPI
11 = 17.1 CPI
Default = X'00.'
An invalid cp parameter causes the CPI default
to be set at the printer, and results in an invalid
SCS parameter check.
Font Titan 17M is equal to 16.67 characters per
inch. The value of 16.67 is used when calculating
orientation.
Refer to the "Y3—Set Default CPI" section of the "Function
Selection via Line (FSL) commands" chapter for the FSL command
that impacts this SCS command.
DSC AND SCS DATA STREAM COMMANDS
default value for CPI applies.
CPI is defined by cp.
3812, 3268, 6262
3812, 3268, 6262
3812
3812
3812, 3268
3812, 3268
2-17