Y14-Enable Graphic Option; Y19-Set Simplex / Duplex - Xerox 4215 Reference Manual

FUNCTION SELECTION VIA LINE (FSL) COMMANDS
Y14—Enable Graphic Option
Y19—Set Simplex / Duplex
3-24
@Y14, n@
Enables connection of IBM 3812 Page Printer using the ida 3812
software. It also enables the use of ida 820 Advanced Funtion
Printing (AFP) software package.
n1
Refer to the "Helpful hints" appendix for recommended settings
to obtain a specific IBM printer emulation.
Refer also to the "Printer Type and Character Set," "Features,"
and "PS Characteristics" functions in table D-2 of the "Printer
Output Area" section in the "Coax communications buffer"
appendix.
Remember It is important not to set this function during normal operation.
Once programmed, the new value should be stored.
@Y19, n@
Selects duplex printing.
Printing on both sides of a paper is enabled with long-edge
binding or short-edge binding (tumble).
n
Orientation of the printing (landscape or portrait) should be
selected in the software controlling the printing, for example,
word processing programs.
Do not use a different page format on the front and the back
side of a paper or the binding edge might have an unpredictable
result.
To make sure that all pages have been ejected while printing in
duplex, set FSL function Y19 to "0" simplex printing at the end of
Values for n1 are:
0 Disable Graphics
1* Enable Graphics
No guarantee for vertical formatting is given if n1
= 0. If n1 = 1 is selected, data exceeding the
maximum print position is lost.
Values for n are:
0 Simplex printing (printing on one side of
the paper)
1 Long-edge binding duplex
2 Short-edge binding duplex
Long-edge and short-edge bindings are printed
in both portrait and landscape.
XEROX MRP FAMILY COAX COMMAND REFERENCE