Y33-Non-Scs, Automatic Function At End Of Job - Xerox 4215 Reference Manual

FUNCTION SELECTION VIA LINE (FSL) COMMANDS
Y33—Non-SCS, Automatic Function at End of Job
3-34
@Y33, n@
Implements an IBM RPQ and takes effect as soon as the
command is received.
position after the print buffer is completed or after an end of
message is received. Settings different from the factory default is
NOT recommended.
n
If n = 0, (default) is selected, on completion of the print buffer,
an Automatic New Line is performed unless the last command
executed was a Form Feed, or the last print position is at
position 1. If Form Feed is the last character in the buffer, the
end of printer buffer options (Y31) is checked.
If n = 1 is selected, on completion of the print buffer, an
Automatic Form Feed is performed unless Form Feed was the last
command in the buffer. The printer is set at print position 1 of
the first line of the next page.
This option only affects NON SCS printing, and corresponds with
the IBM 3268 RPQ SC9507, and the IBM 3287 RPQ SC3740.
Example @Y33, 1@ sets the printer to automatically issue a FF at the end of
a print buffer.
Same print line
Next print line
Next print line
Last print line
This function determines the print
Values for n are:
0* A New Line (NL) is automatically
executed when the printing of a buffer is
completed unless the last command
executed was a Form Feed (FF), New Line
(NL), or a Carriage Return (CR).
1 A Form Feed is automatically executed
when the printing of a buffer is
completed, unless the last command
executed was a FF.
Print position
1 2 3
o
OFF
ON
XEROX MRP FAMILY COAX COMMAND REFERENCE
MPP+1
End of Buffer
Present form
Page boundary
Next form