Xerox 2101 Configuration Manual page 73

4
4-17 Network Setup options
Network Setup
Protocol Setup
TCP/IP Setup
TCP/IP Setup with Ethernet
Ethernet Setup
Enable TCP/IP for Ethernet
Yes/No [Yes]
Select Yes if you have a TCP/IP network connected to the Fiery EX2101 over
Ethernet cabling.
If you are using TCP/IP for printing from Windows computers, enabling
N :
OTE
TCP/IP here also enables you to use Fiery utilities from Windows computers using
TCP/IP protocols.
Enable Auto IP Configuration
Yes/No [Yes]
Select Yes to allow the Fiery EX2101 to obtain its Ethernet IP address by searching the
network. Depending on your network and the protocol you select in the following
option (DHCP or BOOTP), the IP address can change. Select No to assign the
Fiery EX2101 a static IP address. If you select No, you proceed to the IP Address
option, where you manually set the IP address.
Select protocol
DHCP/BOOTP [DHCP]
This option appears only if you answered Yes to Enable Auto IP Configuration. Select
the protocol over which the Fiery EX2101 should search for its IP address. Both
DHCP and BOOTP allow the Fiery EX2101 to obtain the Ethernet IP address and
Subnet Mask automatically.
Depending on your network, the Fiery EX2101 may be assigned a different address
after you restart the Fiery EX2101. With the DHCP setting, the Fiery EX2101 can be
assigned a different address even if it is not restarted. Make sure the network is already
configured properly for the protocol you select.