Port Setup Options - Xerox 2101 Configuration Manual

4
4-15 Network Setup options
T N
O EXIT ETWORK
1. When you have finished entering service settings, choose Exit Network Setup.
2. Choose Yes when prompted to save changes.
3. From the main Setup menu, choose another Setup or choose Exit Setup.
Network Setup
Port Setup
The options are described in detail in the following pages.
S
ETUP

Port Setup options

To configure the Fiery EX2101, choose the port type you use and enter the settings
for that port. Since network setups are nested, the names of higher-level menus are
shown in this chapter to the left of each menu heading.
Ethernet Setup
Enable Ethernet
Yes/No [Yes]
Select Yes if you have Ethernet cabling connected to the Fiery EX2101.
Ethernet Speed
Auto Detect/100 Mbps Full-Duplex/100 Mbps Half-Duplex/
10 Mbps Full-Duplex/10 Mbps Half-Duplex [Auto Detect]
Select an appropriate setting according to the settings of the network to which the
Fiery EX2101 is connected.
When you select Auto Detect, make sure that the auto-negotiation settings
N :
OTE
for speed and duplex are configured for the network port to which the
Fiery EX2101 is connected. Similarly, when you select a different setting, such as
100 Mbps Full-Duplex, make sure the same settings are configured for the network
port.