5
5-14 Setting up the Fiery EX2101 from a Windows Computer
To set the subnet mask, enter one of the following values:
•
255.0.0.0
•
255.255.0.0
•
255.255.255.0
Confirm the subnet mask setting with your network administrator before
N
:
OTE
proceeding. In some cases, the required setting may be different from those listed.
If your TCP/IP network has a gateway and users outside the gateway plan to print to
the Fiery EX2101 using TCP/IP, enter the gateway address.
The Fiery EX2101 stores assigned IP addresses, even if you later disable TCP/IP.
N
:
OTE
If you need to assign the Fiery EX2101 IP address to another device, first set the
Fiery EX2101 address to a null address.
Services
You can configure the following network services:
LPD Printing (TCP/IP)/Enable LPD Printing Service
print services.
NetWare Printing (PServer)/NetWare Services
(see
page
5-15).
Windows Print Sharing (SMB)/Windows Printing Service
print services.
—enable or disable SNMP services (Local Setup only)
SNMP Setup
HTTP Support (WWW)/Enable Web Services
WebTools and IPP printing.
Port 9100 (TCP/IP)/Enable Port 9100
printing.
Email Setup/E-mail Service
if the IP address starts with a number less than 128
if the IP address starts with a number from 128 through 191
if the IP address starts with a number greater than 191
—enable or disable support for Port 9100
—specify the Fiery E-mail Service.
—enable or disable LPD
—specify NDS and Bindery services
—enable or disable SMB
—enable or disable support for Fiery