Ethernet Connection - Xerox 2101 Configuration Manual

1
1-11 Connecting network cable to the Fiery EX2101

Ethernet connection

For Ethernet connections, the Fiery EX2101 supports Unshielded Twisted Pair (UTP)
cabling, defined as Category 5 for use with 100BaseT, or as Category 3, Category 4, or
Category 5 for use with 10BaseT. The cable uses an 8-pin RJ-45 connector that plugs
into the RJ-45 socket on the Fiery EX2101.
The 100BaseT type supported by the Fiery EX2101 is100BaseTX, also known
N :
OTE
as Fast Ethernet. If an Ethernet hub is used, it must be a 100BaseTX hub. The term
"100BaseT" is used to refer to 100BaseTX.
T E
O CONNECT TO THE THERNET BOARD
• Connect the network cable to the RJ-45 connector on the back of the Fiery EX2101.
You must use a Category 5 unshielded twisted pair network cable for 100BaseT and
1000BaseT.