Network Setup; Adapters/Ports - Xerox 2101 Configuration Manual

5
5-8 Setting up the Fiery EX2101 from a Windows Computer

Network Setup

Network Setup configures the Fiery EX2101 to receive print jobs over the networks
used at your site. If the Fiery EX2101 is configured to enable more than one protocol,
it automatically switches to the correct protocol when it receives a print job.
You can view and specify the following network settings in Network Setup:
• Adapters and ports—view currently configured network adapters and port settings
• Protocols—including AppleTalk, IPX/SPX, and TCP/IP
• Print Services—including LPD printing (TCP/IP), NetWare printing (PServer),
Windows print sharing (SMB), SNMP, HTTP support (WWW), Internet Printing
Protocol (IPP) printing, Port 9100 printing, E-mail Service

Adapters/Ports

In local Setup only, the installed network boards are displayed. You cannot change this
information. From remote Setup, you can enable Ethernet. These options are
described in the following section.