Use a magnetized screwdriver to remove the metal screws. Be extremely careful not to
drop any screws down into the printer's chassis. This could cause damage to the
printer which is not covered by the warranty. In this case, contact XANTÉ Technical
Support for information on retrieving the screw(s).
2.
Remove the controller board from the printer.
Do not touch any of the controller board circuitry; handle it by its edges or the
memory bank latches.
a.
Disconnect the LED (fig. 6.16) and MCTRL (Micro Controller; fig. 6.17)
cables by pulling them straight out of their connectors.
Fig. 6.16 Disconnect LED Cable
Fig. 6.17 Disconnect MCTRL Cable
Printing on Various Media and Options – 6-17