Xante AW 1200 User Manual page 112

b.
5. Reinstall the controller board into the printer.
a.
Fig. 6.26 Align Controller Board
b.
Make sure to thread the parallel interface wires through the printer's parallel interface
slot carefully so that they do not get bent.
6-20 – Printing on Various Media and Options
Push the female IDE cable connector securely into the male IDE hard
disk connector (fig. 6.25).
Grasp the controller board by the front, right corner and the left memory
bank latch and align the board over the printer at a slight angle (fig. 6.26).
Lower the controller board carefully into place making sure the interfaces
on the board slide into their respective printer slots (fig. 6.27).
Fig. 6.27 Lower Controller Board into Place