Table of Contents
Advertisement
Shake the cartridge enough to free any compacted toner. Turning on the printer with
toner still compacted may damage the cartridge.
5.
Place the cartridge on a flat surface; then, remove the shutter packing tape by
pulling it down from the top (fig. 1.15).
Fig. 1.15 Remove Shutter Packing Tape
6.
Grasp the sealing tape's end and pull the tape straight out (fig. 1.16).
If the tape is pulled out at an angle, it may break off in the cartridge. If the tape is not fully
removed (approx. 27" [70 cm] long), it will reduce print quality and damage the printer.
7.
Align the cartridge's side ridges with the guide channels in the printer (fig.
1.17). Then, gently slide the cartridge into the printer until it clicks into place.
Fig. 1.17 Align and Insert Cartridge
8.
Close the top cover (fig. 1.18) and then the front cover (fig. 1.19), making sure
both snap into place.
1-12 – Introduction and Installation
Fig. 1.16 Remove Sealing Tape
Fig. 1.18 Close Top Cover
Advertisement
Chapters
Table of Contents
